Sigma LBA-400 Betriebsanweisung PDF herunterladen (Seite 21)

LBA-USB User Guide Document No: 11294 Page 21

The saved configuration file does not include, and thus will not restore data

frames, reference frames, gain correction frames, or Ultracal! processing

information. These types of frames must be saved and restored separately.

Note: Remember to perform an Ultracal! cycle immediately prior to acquiring new data

frames. Since camera calibration, equipment setup and operating conditions can

vary between sessions and even during extended sessions, performing frequent

Ultracal! cycles ensures the highest level of reliable data acquisition.

2.1.5 Restore Config…

LBA-USB setup configurations may be restored from previously saved .usb-cfg

files. Whichever configuration was the last to be restored (or saved), will become

the default configuration the next time the LBA-USB application is launched. The

configuration file includes all setup parameters within the LBA-USB menus.

The saved configuration file does not preserve, and thus will not restore Data

frames, Reference frames, Gain Correction frames, or Ultracal! processing

information. These types of frames must be saved and restored separately.

Perform an Ultracal! cycle immediately prior to acquiring new data frames. Since

camera calibration, equipment setup and operating conditions can vary between

sessions and even during extended sessions, performing frequent Ultracal! cycles

ensures the highest level of reliable data acquisition.

Note: Restoring a configuration does not change any camera settings; it simply

restores the Camera dialog box settings just as they were when the configuration

file was created.

2.1.6 Set Reference

This feature is also available as a button on the toolbar:

Set Reference copies the current frame or the Gauss fit results of the current

frame to the reference frame buffer. The reference frame is located at frame

number 0 (zero), in the frame buffer. View the reference frame by entering a “0”

in the Frame indicator/edit control:

Note: The reference frame 0 does not cycle through using the Frame spin controls.

The Set Reference Source item located in the Capture dialog box determines

the style of the save reference data.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 135 136

Keine Kommentare

Sigma LBA-400 Betriebsanweisung Seite 21